What aisle width do I need for an articulated forklift, and will my existing racking work with it?
Articulated forklifts can work in aisles from 1.6m, depending on the truck; we confirm the exact figure against your truck’s specification. One detail that is often missed: racking end frames need to sit 600mm off the wall so the truck’s pivot point can manoeuvre into a pallet. Existing racking can usually be reconfigured to suit rather than replaced.
Why the truck spec governs
Aisle width is set by the specific truck model, its pivot geometry and your pallet size. There is no generic figure. Two articulated trucks from different manufacturers can need meaningfully different aisles, and the same truck needs different aisles with different pallet sizes on the forks. We work from the truck’s datasheet and your actual pallet dimensions, never from the brochure headline, because the difference between the two is exactly where layouts go wrong.
The 600mm rule
The pivot point under the forks needs room to swing the load into the first pallet position at the end of each run, which is why end frames are set 600mm off the wall. Miss that clearance and the end bays become slow or unusable: the driver cannot square the load into the position, every placement takes longer, and the racking at the run ends starts collecting strikes. It is a small dimension that decides whether the whole end of a run earns its keep, and it is one of the details a specialist layout gets right and a generic one misses.
Getting the margin right, not just the minimum
The tightest aisle the datasheet allows is not automatically the right aisle. A layout squeezed to the theoretical minimum can leave drivers fighting the aisle every shift, and the cost of that arrives as continual rack damage and downtime rather than as one visible mistake. The right width is the one that maximises storage while leaving the truck a workable margin, which is a design judgement made from the truck spec, the pallet size and how your drivers actually work.
Reusing what you own
In most conversions the racking you have is re-set to the new layout by an installation team: frames moved, runs re-spaced, beam levels adjusted, new components only where the design needs them. You pay for reconfiguration and the margin of new parts, not for a new system, and the work is phased so the operation keeps running around it.
Also asked…
Can articulated trucks and counterbalance trucks share one warehouse?
Yes, in zones. Many sites run articulated trucks in a narrow aisle storage block and counterbalance for loading, yard work and wide aisle areas, with each zone’s aisles designed for its truck.
Do I need to close the warehouse during a reconfiguration?
Normally no. The work is planned area by area: stock is moved out of one section, that section is re-set, stock goes back, and the team moves on. You keep trading throughout.
What do you need from me to confirm the aisle width?
Three things: the truck model or datasheet, your pallet size and weight, and your current aisle widths. With those we can tell you whether your racking works as it stands, or what the reconfiguration looks like.
Complete Solutions. Proven Expertise.
Tell us your truck model and current aisle widths and we will confirm whether your racking works with it, and what a reconfiguration would involve.